|Kondisi barang :||Baru|
USB-CIF02 programming cable simulates USB port as traditional serial port (usually COM3).After connected with CS1W-CN114 cable,it can also be connected with CS/CJ,CQM1H and CPM2C series PLC,3 m.
USB-CIF02 USB interface Cable for Omron series PLC
USB-CIF02:USB interface Omron series PLC programming cable,with communication indicator,cable connection between CQM1,CPM1,CPM1A,CPM2A,C200HS,C200HX/HG/HE,SRM1 series PLC and the computer.After connected with CS1W-CN114 cable,it can also be connected with CS/CJ,CQM1H and CPM2C series PLC,3 Meters.
USB-CIF02 is the programming cable in which USB interface provided both the serial connection and RS232 signal conversion. Under the control of computer-driven driver,programming cable makes it possible for the computer’s USB interface to simulate the traditional serial (known as COM interface),thus various existing programming software such as communications software,monitoring software and other applications can be normally used.The working power supply of this cable is directly from the USB port,but not the PLC programming interface.The two-color LED on the converter box indicates data’s transceiving status.
USB-CIF02 is applicable to Omron PLC,with a direct connection to CQM1, CPM1,CPM1A,CPM2A,CPM2B,CPM2AH,C200HS, C200HX/HG/HE and the interface of the SRM1 series PLC;for CS/CJ,CQM1H and CPM2C series PLC,USB-CN226 programming cable should be choosed,but also the case should be that the use of USB-CIF02 after CS1W-CN114 cable adapter.
Note: USB-CIF02 can not be used to the old model C200H, C_ _ H, C500-AP003, 3G2A5-AP003 series PLC.
Features and technological index:
Support USB-CIF02 operating system:Windows2000/XP (WinNT4/95/98/Me/DOS not included )
Support USB-CIF02 programming software version:CX-Programmer V1.0 and above
USB-bus powered,with current consumption of 50 mA
Baud rate:300 bps~1Mbps automatically adapt to the standard baud rate
Support UART data format:data bits: 7-8; stop bit:1, 2; check-bit:odd/even/no parity
Each PC only supports one USB cable programming
Working temperature:-20~+75 ℃
Cable length:3 m;
USB device drivers should be installed before using USB-CIF02 programming cable,which are available on the CD-ROM sold together with the cable.And for the specific installation steps,please refer to the instruction files on the CD-ROM drivers,and details are not necessarily listed here.
After completing Driver installation,the corresponding COM port for the USB-CIF02 programming cable will be displayed in the “Device Manager” of Window.The step next is just to choose this COM port in the programming software and other application software and keep other communication parameters as in the Default settings.And the following steps are exactly the same as in the traditional programming cables with RS232 interfaces.
USB-CIF02 programming cable does not support long-distance communication.For long-distance communication,RS485/422 communication module can be chosen (model: FS-CIF11),which makes dozens of PLC communicate,with the largest communication range of up to 2 Km.